If the targets on your course have changed positions, this can be updated via your Course Tools in a few simple steps.
1. Verify that your Smart Layouts have been set up properly, using the target Type and not Position.
2. Open the Quick Targets tab of your Course Tools.
3. If all targets are in the same position, you can adjust this at the top, and apply to all holes below.
4. If each hole has the target in a different position, this can be adjusted one hole at a time.
5. After updating the position for each hole, Apply Changes at the bottom. Once this is approved, your properly created Smart Layouts will update accordingly.
If you see the below error, it is likely your Smart Layouts are not set up properly. Take a look at this article for tips on fixing your Smart Layouts!
This is the process for moving an existing target to a pin position that already exists on your Map Manager. If you don't have multiple pin positions, but instead need to reposition a tee or target, you can learn how to do so here. If you need to add a new available target position, check out this article!
If you need any further assistance, please contact help@udisc.com.